it detects the voltage, and based upon the H_V setting within it, it decides that the ARKOK is acceptable and starts to control the THC relative to the setpoint voltage up and down. You cannot turn the THC OFF with the Proma SD. 60 above the steel and ran a job, I thought it would run run without moving up and down at all but it does not. I also thought if I turned off THC and set the torch at. I love this site and all the support, Thank you to all the educated helpful members. My thought is remove Sheetcam again and reload it. I think I can still save it but 4 holes are a loss. This is when things got magnified and I basically have screwed up a 4x4 sheet. Today, I was hoping to cut a 1/4 HR sheet and cut out a welding table found here on the site. Just my guess, wish I knew more now on these tables. I think I was getting away with cutting small things because it was so thin. However, I notice that almost every other cut it would take off to the cut by dragging. Take off head to first cut, drop to table, lift and start cutting and is lowered or lifted as it should. I thought anyways, so I have notice cutting thin metal 16 ga, that it seems like when the torch started it would work correctly. It was determined that sheetcam had a software issue and deleted from the computer and re-installed it and all was good. I called Jake the owner after a few days of working on it at a total loss and he actually came to my house and fixed the issue. A few months bank I was wiring up the THC and after I could read all the volts and settings on the unit I could not get my table to work correctly for days. I'm new to plasma cutting and having an issues.
I have a premier plasma 4x8 flat deck, running a xp45 with SD Promo TCH.
0 kommentar(er)
